Acetylene Torch Settings Chart

Acetylene Torch Settings Chart – Turn on both valves slowly by twisting them. 257 views 3 years ago. The third open valve in the torch is the first acetylene after that you. Lighting up when lighting the torch, it’s important to remember that oxygen comes out first, followed by acetylene gas coming out second.

Open regulator oxygen and acetylene, set until the pressure matches with what you want or for acetylene 5 to 7 psi and oxygen 7 to 10 psi. Pure oxygen is used for the cutting jet and it's mixed with either acetylene, propane, or commercial gas to provide the preheat. To set up the torch, first attach the oxygen and acetylene tanks to the torch, then adjust the regulators to the proper pressure. So, this torch may be easy to use, but it can burn and explode if.

Acetylene Torch Settings Chart

Next, use the torch’s valves to control. Before you even think about lighting the torch, make sure. Burning acetylene gas is the key point to produce much heat or energy and the temperature could be 5620 degrees.

The ratio of these gases can. This article covers the standard type of cutting torch which is an acetylene torch set up. · stand away from front of regulator · separately and slowly open the oxygen and acetylene cylinder valves · adjust regulator p/a screws to tip pressure settings · open/close torch.

How to setup a oxy acetylene torch set is simple just watch and learn how also what to set your oxy and acetylene pressure on your.

Oxy Acetylene Cutting Pressure Chart